GlennM
Member
I have 3 new PowerFlex 7000 VFD's. Rockwell was out to do some checking before startup. These are part of a larger electrical project. I gave the tech the ip addresses, and he changed them at the VFD and the Panel View. I can ping the VFD and it answers but I cannot connect to them through CCW or Studio5000. I can connect directly with CCW and pulled the parameters out.
The 20-comm-er BOOTP is enabled, but also the IP address shows up in the parameters. When I use the interface to disable BOOTP and put in the address manually, it tells me that it is a duplicate address. I have been scouring the inet for too many hours to solve this and establish communications. Any help would be appreciated. I need to get connect to these before startup.
The 20-comm-er BOOTP is enabled, but also the IP address shows up in the parameters. When I use the interface to disable BOOTP and put in the address manually, it tells me that it is a duplicate address. I have been scouring the inet for too many hours to solve this and establish communications. Any help would be appreciated. I need to get connect to these before startup.