Setting up keyboard macros

ArcReactorKC

Member
A
Join Date
Jun 2021
Location
Midwest
Posts
70
I am gearing back up my Rockwell and GE/Emerson setup and building my new macro keyboard.

What is everyone's favorite studio 5000 and GE proficy macros?

I know I'm constantly using
alt+ins OTE
alt+ins XIO
alt+ins XIC
alt+ins TMR
alt+ins CTE


I'm sure there are more that are commonly used I've forgotten since I quit using my old razer Tartarus awhile
 

Similar Topics

Rsflipflop256
Setting up a modbus network on a DL262 Directlogic PLC with Siemens LMV 3 Burner controllers as slaves, eight of them, with OCI 412.10 Interface
Good morning fellow sea captains and wizards, I am being asked to do the above and obtain 4 values from each slave, I know about the MRX and MWX...
2 3
Replies
32
Views
837
Rsflipflop256
Rsflipflop256
T
SETTING UP I/O USING LOGIXPRO RS 500 EMULATOR
SELECTED NEW FILE SELECTED PROCESSOR TYPE SELECTED I/O CONFIGURATIONS IM UNABLE TO CONFIGURE MY I/O’S. I HAVE A PAPER COPY OF A PROGRAM AND I...
Replies
0
Views
81
TFLARIS
T
L
Resetting old RSLINX Master Disk floppy
Does Rockwell still offer reset codes for old school Master Disk floppy's? In a bind and need to reset the activation disk soon and to be pointed...
Replies
9
Views
230
LMDAVE
L
U
Setting up WAGO PFC 200 750-8216 as a Profibus Slave
Hello, I am in possession of a WAGO PFC 200 750-8216 which I was successfully able to set up as a Modbus RTU Master to a slave device using...
Replies
0
Views
87
udit_91
U
M
Prosoft AN-X4 DH+ to Ethernet Gateway -- setting up HMI
Hello. I am trying to use a Prosoft AN-X4 to improve the communications for a new panelview plus 7. This is going from a SLC-500 through DH+ to a...
Replies
9
Views
291
TheWaterboy
TheWaterboy
Back
Top Bottom