Hi there ,i'm using a CQM01 PLC for my project. I was just testing the input and output of my PLC with a very basic program with only one contact and one coil. When I switch on the input contact the line goes green but the output coil doesn't , but when I set the coil to 1 (on) from cxprogrammer, the physical output turns on and the indicator lights up too , so I don't think there's any problem in the wiring or addressing.
--[]--------O--
My current DIP switch setting is :
1 : OFF
2 : OFF
3 : ON
4 : ON
5 : ON
6 : OFF
When I tried the same program using a PRO01 Programming Console it worked.
So my question is why won't the output coil in cxprogrammer and output indicator on the output module won't light up ?
The PLC was already on monitor mode when I tested it.
Any help is greatly appreciated
--[]--------O--
My current DIP switch setting is :
1 : OFF
2 : OFF
3 : ON
4 : ON
5 : ON
6 : OFF
When I tried the same program using a PRO01 Programming Console it worked.
So my question is why won't the output coil in cxprogrammer and output indicator on the output module won't light up ?
The PLC was already on monitor mode when I tested it.
Any help is greatly appreciated