best49erfan
Member
I have an Allen Bradley 150-C16NBR that I have wired as below:
L1----SS-----T1
L2----SS-----T2
L3----SS-----T3
+24-----------A1
|
---------[On SW]----------IN1
|-----IN2
Note: IN2 is after the On SW
COM----------A2
This is how it shows to do it for 2 wire control in the manual. When the On SW is closed, the motor starts up and then shuts back down with no faults. It keeps repeating this until you turn the switch off.
Any ideas on what the problem could be?
L1----SS-----T1
L2----SS-----T2
L3----SS-----T3
+24-----------A1
|
---------[On SW]----------IN1
|-----IN2
Note: IN2 is after the On SW
COM----------A2
This is how it shows to do it for 2 wire control in the manual. When the On SW is closed, the motor starts up and then shuts back down with no faults. It keeps repeating this until you turn the switch off.
Any ideas on what the problem could be?
Last edited: