Siemens S7 200 Retentive Counter

Copper

Member
C
Join Date
Nov 2023
Location
Colorado
Posts
1
Having trouble with a Siemens S7 226 counter being retentive. I have specified in the System block C ranges offset 0, 6 elements. However, at power cycle, the counter is reset to 0. The Counter is C5 and is in a subroutine. Not sure what I'm doing incorrect. Any suggestions as to make the counter retentive?

SysBlockRetentiveRange.JPG Network3_C5.JPG
 

Similar Topics

K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
257
KalvMavin
K
H
comment communique siemens s7-1200 avec vfd delta
commentaire communiqué siemens s7-1200 avec vfd delta ? (cablage et sur tia portal )
Replies
0
Views
139
houssem02
H
M
Siemens S7 1200 CP2341 ethernet
Hi, I have a 1214 on ip 192.168.0.100. This is connected to other modules through a switch on same network. I need to connect this to a company...
Replies
1
Views
183
tarik1978
T
G
Siemens S7-1200 firmware upgrade
Hi Experts, I would like to make firmware upgrade from v3.0 to v4.5 (S7-1200 CPU 1215C). Can I do it from v3.0 to v4.5? Do I need to take some...
Replies
6
Views
295
goghie
G
R
Siemens S7-1200 profinet communication with codesys plc
Hi Guys, I am trying to establish communication over profinet between Siemens S7-1200 PLC as IO device and codesys plc as IO controller. But I am...
2 3
Replies
43
Views
2,880
raghu_k
R
Back
Top Bottom