KalvMavin
Member
Hi all,
Currently having trouble getting a speed reference to write over modbus to an Omron M1...
I can successfully write a run command and have confirmed the two devices are communicating.
I'm struggling with the documentation for the Omron M1, if I'm honest.
I've attached a snip of the MB_MASTER block I'm using for the run command. This is working well, however, being relatively unfamiliar with Modbus, I'm unsure what to enter in the block parameters to successfully write a speed reference to the drive.
I've also attached a snip of the M1 manual. I believe I should be writing to S05, to give the drive a run command, but unsure as it doesn't appear to have worked when I try.
Any help, much appreciated!
Currently having trouble getting a speed reference to write over modbus to an Omron M1...
I can successfully write a run command and have confirmed the two devices are communicating.
I'm struggling with the documentation for the Omron M1, if I'm honest.
I've attached a snip of the MB_MASTER block I'm using for the run command. This is working well, however, being relatively unfamiliar with Modbus, I'm unsure what to enter in the block parameters to successfully write a speed reference to the drive.
I've also attached a snip of the M1 manual. I believe I should be writing to S05, to give the drive a run command, but unsure as it doesn't appear to have worked when I try.
Any help, much appreciated!