Kataeb
Member
Kindly, what do they mean by the below "..." ?
We frequently use Motion Axis Gear (MAG) with an incremental MAM instruction .
What happens if the ratio is not one ?
" Normally a gear ratio of 1 is used with phase adjustment.
A 1:1 ratio ensures that the computed phase error does not change before performing the move to correct it. "
(Rockwell Automation Publication MOTION-RM002J-EN-P-October 2020)
>>> page 131
https://literature.rockwellautomation.com/idc/groups/literature/documents/rm/motion-rm002_-en-p.pdf
We frequently use Motion Axis Gear (MAG) with an incremental MAM instruction .
What happens if the ratio is not one ?
" Normally a gear ratio of 1 is used with phase adjustment.
A 1:1 ratio ensures that the computed phase error does not change before performing the move to correct it. "
(Rockwell Automation Publication MOTION-RM002J-EN-P-October 2020)
>>> page 131
https://literature.rockwellautomation.com/idc/groups/literature/documents/rm/motion-rm002_-en-p.pdf