banditpowdercoat
Member
I've replaced one of our Powerflex 700 drives in our gensets. Old one was a FW 8.002 New one 10.001 through a 20 comm e card, now in RSlogix5K it shows up with code 16#116 Electronic keying mismatch. Originally, the FW selection tabs were visible, but I figured our RS5K was a older version. Updated. Now its V17.01.00 (CPR 9 SR 1) Installed Firmware Support:
v13
v15
v16
v17
v18
v19
But the FW version tabs are now greyed out. The right FW is there offline. Does this mean I have to do changes offline then download? This PLC is running our gensets and we can't afford a blackout/shutdown. I read after SW version 165 you can change onlline? But I can't What am I missing? I am more SLC/PLC5 programmer, not a lot of control logix experience.
v13
v15
v16
v17
v18
v19
But the FW version tabs are now greyed out. The right FW is there offline. Does this mean I have to do changes offline then download? This PLC is running our gensets and we can't afford a blackout/shutdown. I read after SW version 165 you can change onlline? But I can't What am I missing? I am more SLC/PLC5 programmer, not a lot of control logix experience.