Hi,
I'm encountering a fault on a remote I/O node that is communicating with a Genius Bus Controller.
The site can not risk stopping the machines, so I was hesitant to clear the faults displayed in the fault table. Does anyone know if it is safe to do this, and would it fix the fault? I know there could be a device problem that may have triggered the fault in the first place that may need looking at.
I'm encountering a fault on a remote I/O node that is communicating with a Genius Bus Controller.
The site can not risk stopping the machines, so I was hesitant to clear the faults displayed in the fault table. Does anyone know if it is safe to do this, and would it fix the fault? I know there could be a device problem that may have triggered the fault in the first place that may need looking at.
Last edited: