Mas01
Member
We've got a portable cooling pump which circulates a coolant oil.
The spec says it can be remotely operated (coolant START/STOP), via a 3-pin connector:
[FONT=Calibri,Bold][FONT=Calibri,Bold]
[/FONT][/FONT]PIN A...+24VDC from pump supply
PIN B...Start by momentary connection to PIN A
PIN C...Stop by momentary connection to PIN A
QUESTION: To connect this to our PLC (Mitsubishi Q-series), do I need to connect wires B & C to a "QY18A 8 Relay Outputs" card (we have a spare channel), then create a "toggle" switch on the GUI to control the Start/Stop control? Thanks
The spec says it can be remotely operated (coolant START/STOP), via a 3-pin connector:
[FONT=Calibri,Bold][FONT=Calibri,Bold]
[/FONT][/FONT]PIN A...+24VDC from pump supply
PIN B...Start by momentary connection to PIN A
PIN C...Stop by momentary connection to PIN A
QUESTION: To connect this to our PLC (Mitsubishi Q-series), do I need to connect wires B & C to a "QY18A 8 Relay Outputs" card (we have a spare channel), then create a "toggle" switch on the GUI to control the Start/Stop control? Thanks