MereNonsense
Member
Hi.
I am trying to understand some old code for B&R 2005 PLC created in PG2000 software. There are procedures concerning axes but I cannot find their description. And in general I lack some quick start for axes..
So maybe you have some document that describes how to work with axes via the NC154 module?
Thank you.
I am trying to understand some old code for B&R 2005 PLC created in PG2000 software. There are procedures concerning axes but I cannot find their description. And in general I lack some quick start for axes..
So maybe you have some document that describes how to work with axes via the NC154 module?
Thank you.