Kinetix 300

tjntjntjn

Member
T
Join Date
May 2012
Location
USA
Posts
94
Hey there. Just quick question. I just want to confirm if this is right. I'm trying to send a value to Kinetix 300 parameter (let's say distance to run to index 0 or any other) using explicit message but I get an error when trying to send REAL tag value (value with decimal places).
My question - can real value be sent or it has to be only tag with no decimal places?

Thanks
 

Similar Topics

U
allen bradley kinetix 300 E11 fault code
in allen bradley kinetix 300 drive first E31 error shows after resting drive E11 error occurs need solution to reset E11 fault code
Replies
4
Views
165
robertmee
R
B
Kinetix 5300 MSO causing ExcessiveVelocityErrorFault
Have a system that has been running for over a year and all of a sudden getting a ExcessiveVelocityFault on one of the drives when the MSO command...
Replies
2
Views
169
padees
P
O
Re-Zero a Kinetix 5300/MPAI Electric Cylinder
Hello PLCS.Net Forum, First time posting. Let's assume I am a novice. BASIC PROBLEM: My servo/linear piston is no longer zeroed to the...
Replies
9
Views
259
OhNo
O
T
Kinetix 300 IP address
Hello. I have a few machines that use Kinetix 300 (each machine has two drives). Both drives on one of the machine keep losing IP address. They...
Replies
2
Views
112
tjntjntjn
T
N
MSG error after 10 years Kinetix 300 1769-L35E
Hello, We have had a machine running for the last 10 years. It has 2 x Kinetix 300 drives. Around a year ago, one of the drives failed. We were...
Replies
1
Views
462
Nortech
N
Back
Top Bottom