Connect Sinking Analog Sensor to Delta Analog Module

Mray

Member
M
Join Date
Mar 2018
Location
Toronto
Posts
90
Hi,
I am working on a project with Delta PLC for the first time. I want to connect a Sinking analog sensor (4-20 mA) to a Delta analog module (dvp06xa). I am in doubt that whether it is possible or not. Please help me to figure it out.



Please see the attached photos as:
Photo #1 = Sensor wiring diagram
Photo #2 = Sensor pin out
PDF = Analog Module Manual

1.jpg 2.jpg
 

Attachments

  • DVP06XA-S.pdf
    296.4 KB · Views: 10

Similar Topics

K
Configuring Stratix 5400 to connect to a Stratix 5700
Greetings, I had an issue with a RIO rack 2 and IFM I/O Link dropping on my network. I would loose connection for a second or 2 then they would...
Replies
3
Views
104
harryting
H
Suhail
help me out to connect lenze i700 to PC
Hi friends, i need a help to know the procedure and steps to connect Lenze i700 to PC for parameterize. i tried with lenze easy-starter using LAN...
Replies
0
Views
58
Suhail
Suhail
Z
SCADA Pack RTU 474, IO card (5606) Not responding in Remote Connect
Hi, We have been facing a issue with SCADAPack 474. Configuration is like below. RTU 474 + 6103 PS + 5606 IO Mix Module + 5414 DI Module Only...
Replies
0
Views
76
Zubairjaved786
Z
S
Siemens PLC Main Disconnect Trip
The past week we received a new piece of equipment from Germany which utilizes siemens controls. Typically in our company we use A.B. controls for...
Replies
12
Views
372
JesperMP
JesperMP
C
MSG instruction connect failure between ControlLogix5572 and MicroLogix 1400.
I'm using a SLC typed write from the ControlLogix5572 to the MicroLogix 1400, with path: 2, (MicroLogix IP). The ControlLogix equipment has a...
Replies
0
Views
127
Chris3EC
C
Back
Top Bottom