merchantg
Member
Wondering if any of you old timers have seen a case where you can download to the processor no problem, but on power cycle: fault, and no program? Three separate processors, 2 are new. Fresh batts in all.
I checked my load bits for memory module everything is set low. I have no problem reloading any of the processors and they run fine until next power cycle.
I'm scratching my head on this one. I have changed out hundreds of processors no problem, well not usually.
P.S. Ron if your around just want to give you a shoutout. I sent several techs your way a few years back. Excellent training my man. I heard you were retiring back then, hope your doing good.
I checked my load bits for memory module everything is set low. I have no problem reloading any of the processors and they run fine until next power cycle.
I'm scratching my head on this one. I have changed out hundreds of processors no problem, well not usually.
P.S. Ron if your around just want to give you a shoutout. I sent several techs your way a few years back. Excellent training my man. I heard you were retiring back then, hope your doing good.