I added a few JPGs on here.
Buttons on the HMI turn on Outputs on the PLC.
Also Indicators display the status of the inputs.
The Numeric Display shows the FW version not sure if it's right but I get numbers, pay attention to the format of the ND on the HMI, I believe I set it up for Unsigned 16 bit under its properties.
The Modbus stuff are visible on the screen as far as what to use to access the elements (Registers & codes).
Hope this helps.
Buttons on the HMI turn on Outputs on the PLC.
Also Indicators display the status of the inputs.
The Numeric Display shows the FW version not sure if it's right but I get numbers, pay attention to the format of the ND on the HMI, I believe I set it up for Unsigned 16 bit under its properties.
The Modbus stuff are visible on the screen as far as what to use to access the elements (Registers & codes).
Hope this helps.