Hi i'm fairly new to plc programming. I'm having an issue connecting to a logix5555 plc with an rs232 cable. The linx and logix software has just been installed and hasn't connected to any plc using rs232 before.
When i attempt to configure the driver i get the error message "Can't find baud rate and parity"
I've tried every combination of baud rate and parity without any success. Is there some sort of driver software needed or do i need to configure it through the kepware software??? I'm at a total loss as to why i can't get it to work
When i attempt to configure the driver i get the error message "Can't find baud rate and parity"
I've tried every combination of baud rate and parity without any success. Is there some sort of driver software needed or do i need to configure it through the kepware software??? I'm at a total loss as to why i can't get it to work