Johnny T
Member
Hi
I am doing some alterations to three palletisers, two of them have TI 535 PLC's, and one has a Simatic 535. They all look exactly the same so I'm assuming the latter is just rebadged after Siemens took Texas Instruments over.
Does anyone know what the software package is called that I'd need to 'talk' to these PLC's. I'm assuming that my S5 software is no good for these.
There are two ports on the front, a 9 pin D-type RS422 and a 15 pin D-type RS232. If anyone knows where I can find a pin-out for a lead then that would also be appreciated.
Thanks for your help
Cheers
JT
I am doing some alterations to three palletisers, two of them have TI 535 PLC's, and one has a Simatic 535. They all look exactly the same so I'm assuming the latter is just rebadged after Siemens took Texas Instruments over.
Does anyone know what the software package is called that I'd need to 'talk' to these PLC's. I'm assuming that my S5 software is no good for these.
There are two ports on the front, a 9 pin D-type RS422 and a 15 pin D-type RS232. If anyone knows where I can find a pin-out for a lead then that would also be appreciated.
Thanks for your help
Cheers
JT