gbradley
Lifetime Supporting Member
Here is the process that I go about Changing the IP address of my laptop to match the Network that my PLC and HMI are on.
Settings: Network & Internet:ChangeAdapterOptions:Internet Protocol Version 4 (TCP/IP/v4)
I always set my Laptop IP Address to the first address in the Network
010|001|001|001
Then I set my Subnet Mask to 255.255.240.0
I am done connecting, and want to get back on the Office network, I choose Obtain an IP address Automatically
This works for me but every time I go through this, I wonder: Is this how everybody does this?
Seems like a lot of steps
Settings: Network & Internet:ChangeAdapterOptions:Internet Protocol Version 4 (TCP/IP/v4)
I always set my Laptop IP Address to the first address in the Network
010|001|001|001
Then I set my Subnet Mask to 255.255.240.0
I am done connecting, and want to get back on the Office network, I choose Obtain an IP address Automatically
This works for me but every time I go through this, I wonder: Is this how everybody does this?
Seems like a lot of steps