I swapped out a PF 527 drive that has been giving me occasional faults.
I replaced with a new 527, assigned its IP and gateway and cycled power.
When it powered up I could go online with controller via Studio5000 but had an I/O fault (blinking green light) and lost communication to all the drives. They all had the little yellow exclamation mark next to them.
I recall that this has something to do with the safety signature not being assigned to the new drive.
Problem is I can't connect to any module in order to change it.
Anyone care to shed some light on the procedure of how to reset this mod fault?
I ended up just putting the bad drive back in until I figure this out.
Thanks
I replaced with a new 527, assigned its IP and gateway and cycled power.
When it powered up I could go online with controller via Studio5000 but had an I/O fault (blinking green light) and lost communication to all the drives. They all had the little yellow exclamation mark next to them.
I recall that this has something to do with the safety signature not being assigned to the new drive.
Problem is I can't connect to any module in order to change it.
Anyone care to shed some light on the procedure of how to reset this mod fault?
I ended up just putting the bad drive back in until I figure this out.
Thanks