PowerFlew Drive, Remote Control

[Caleb_newprog]

Hey guys,

Wanted to make a thread so you guys can teach me things! Anyways, I have a powerflex 525 that has a control module outside of the panel. The only thing that works on this remote is the stop button for the drive. And I cannot press the start button on the remote to start it up again I have to open the cabinet and press it on the drive itself. How can I fix this? I have attached pictures for reference. Also, I cant even change the Hz on this remote too!

 

[drforsythe]

Check the value of P046 - Start Source. I think it needs to be set to 3 for "DSI" when using a remote HIM. I usually use E/IP or digital I/O as the start source, so I could be wrong. Reference the user manual for the drive for the related parameters for start source and speed references.

 

[Robb B]

I'm not certain on this, but I think you need a parameter to enable the remote module. I think a stop will always work for safety reasons.

 

[drforsythe]

Robb B is correct. Any of the available stop sources will induce a stop. The start source will need to be set in parameters.

 

[Caleb_newprog]

Hey guys!! Thanks for the answers and yes you guys were correct! I change the source to DSI and that was the fix, but one more question. Can I now change the Hz on this remote or do I still need to do that on the drive parameters itself?

 

[drforsythe]

You'll need to change P047 to 3 if you want to set the speed through DSI.