gtsuport
Member
Good Morning,
I am converting a program from an old Panasonic NAIS FP0.
Please see the attached section of logic.
Step 637 when the program starts the value in DT1654 should be moved to Timer 41 - 45 set value, as I understand it.
Issue is these timers do not appear in the program logic.
Any input as to what is happening here would be appreciated.
Thanks,
gtsuport
I am converting a program from an old Panasonic NAIS FP0.
Please see the attached section of logic.
Step 637 when the program starts the value in DT1654 should be moved to Timer 41 - 45 set value, as I understand it.
Issue is these timers do not appear in the program logic.
Any input as to what is happening here would be appreciated.
Thanks,
gtsuport