Ken Roach
Lifetime Supporting Member + Moderator
This is a new thread spawned from an old one about small integrated servomotors that connect well with Rockwell Automation control systems. It turned into a discussion of the control of JVL integrated servos with the EtherNet/IP option board (MAC00-EI4 or -EI41).
User ATU has a MAC400 servomotor that he wants to run with an SLC-5/05 controller using the Ethernet Explicit Message instructions.
I have a project with 100 axes of MAC800 servomotors that I'm doing design and layout for, also using the EtherNet/IP option board. But I'm using a big ControlLogix 1756-L71 and three 1756-EN2T modules.
I have just one of the MAC800 on my bench for testing.
User ATU has a MAC400 servomotor that he wants to run with an SLC-5/05 controller using the Ethernet Explicit Message instructions.
I have a project with 100 axes of MAC800 servomotors that I'm doing design and layout for, also using the EtherNet/IP option board. But I'm using a big ControlLogix 1756-L71 and three 1756-EN2T modules.
I have just one of the MAC800 on my bench for testing.