Hi All,
In FB and FC that are compiled it to STL language.
When i open it those FB and FC, i have noticed that every start and End of code is written below.
SET
SAVE
= L 0.1
//
CODES
ARE
HERE
//
A L 0.1
SAVE
BE
So, my question is that, is it the good practice to write my own FC/FB to follow the same above? and as my understanding is correct, this L 0.1 is temp area of FB/FC and only can use inside FC/FB. Why compiler is start used this L 0.1 instead of using L 0.0 without declare anything in FC/FB? i am confused and I need suggestion from GURUs of forum. Thanks!
In FB and FC that are compiled it to STL language.
When i open it those FB and FC, i have noticed that every start and End of code is written below.
SET
SAVE
= L 0.1
//
CODES
ARE
HERE
//
A L 0.1
SAVE
BE
So, my question is that, is it the good practice to write my own FC/FB to follow the same above? and as my understanding is correct, this L 0.1 is temp area of FB/FC and only can use inside FC/FB. Why compiler is start used this L 0.1 instead of using L 0.0 without declare anything in FC/FB? i am confused and I need suggestion from GURUs of forum. Thanks!