Hello,
Am running my FTView 6 project from my PC.
Am connected to my PLC L24ERQBFC18. When I run 'Test Application' the screens are fine and allow me write & read to variables in PLC.
When I compile the FTView program I get the message attached below saying the panelView 600 with firmware 3.1 does not support the L24ERQBFC18.
The screen on panelview generate errors when I try access variables.
Is it really an upgrade to PanelView that I require - OR is there something false in my configuration?
Thanks,
Eoghan
*** Start RSLinx Enterprise Conversion Messages ***
WARNING: Unsupported device detected. Shortcut name = "plc". Device name = "TB1_Sonics". Description: The system has detected that a device type that was not supported in the requested version is referenced by a shortcut. If the system upon which this project is to be run has received a patch that adds support for this device type, then this situation will not cause any problems. Otherwise runtime errors will be detected and logged by the target system when it attempts to communicate to that device.
*** End RSLinx Enterprise Conversion Messages ***
Validation completed with warnings. The runtime application has been created.
CAUTION: Running this application might produce errors at runtime.
Am running my FTView 6 project from my PC.
Am connected to my PLC L24ERQBFC18. When I run 'Test Application' the screens are fine and allow me write & read to variables in PLC.
When I compile the FTView program I get the message attached below saying the panelView 600 with firmware 3.1 does not support the L24ERQBFC18.
The screen on panelview generate errors when I try access variables.
Is it really an upgrade to PanelView that I require - OR is there something false in my configuration?
Thanks,
Eoghan
*** Start RSLinx Enterprise Conversion Messages ***
WARNING: Unsupported device detected. Shortcut name = "plc". Device name = "TB1_Sonics". Description: The system has detected that a device type that was not supported in the requested version is referenced by a shortcut. If the system upon which this project is to be run has received a patch that adds support for this device type, then this situation will not cause any problems. Otherwise runtime errors will be detected and logged by the target system when it attempts to communicate to that device.
*** End RSLinx Enterprise Conversion Messages ***
Validation completed with warnings. The runtime application has been created.
CAUTION: Running this application might produce errors at runtime.