KEN_KACEL
Member
Every time I power this unit up it loses its IP address and goes to DHCP . When I goto the config the IP address is 0.0.0.0
Allen Bradley 2711P-B6M5A Ser D PanelView Plus 600 Touchscreen Keypad
- Thread starter KEN_KACEL
- Start date
Ken Roach
Lifetime Supporting Member + Moderator
In general, you need to use the configuration menus to disable BOOTP/DHCP. Trying to do so using RSLinx Classic, like you can with a PLC, does not (to my knowledge) result in that parameter being correctly and permanently set because it's part of the Windows CE operating system, not the CIP TCP/IP Object like in a ControlLogix.
Similar Topics
hi everyone,
I'm trying to setup communication between a PV600 (with 2711p-rn3 DH485 COMM module) and a slc500 5/02 plc.
I'm using a direct...
in allen bradley kinetix 300 drive first E31 error shows after resting drive E11 error occurs need solution to reset E11 fault code
Hi, I have a ControlLogix system with 1756-IF16 analogue inputs. I can't scale the inputs at the card as there is a requirement to facilitate...
Dear community,
I am trying to find a tool for Allen-Bradley PLCs similar to SiVArch for Siemens PLCs to automatically generate faceplates and...
Hi everyone, new to forum. Since very long time i having issue with 1734-AENT module, after some period of time its keep stuck in error (simmilar...