foggers
Member
Hello All,
I'm sorry that this will have been asked a thousand times, but I cannot find the specific question to search for. I am looking for advice on what basic set-up I need to learn and test EthernetIP using the cheapest AB PLC setup. We supply equipment which has an EthernetIP interface available, and I need to be able to understand it and demonstrate it. I'll be looking for secondhand hardware with processor, a few 24V I/O and the ability to run as EIP "master" (though at this point, I'm not sure whether that is the right term to use!!). I obviously need to get the cheapest AB software that will do the job.
Any pointers gratefully received.
Thanks very much
Foggers
I'm sorry that this will have been asked a thousand times, but I cannot find the specific question to search for. I am looking for advice on what basic set-up I need to learn and test EthernetIP using the cheapest AB PLC setup. We supply equipment which has an EthernetIP interface available, and I need to be able to understand it and demonstrate it. I'll be looking for secondhand hardware with processor, a few 24V I/O and the ability to run as EIP "master" (though at this point, I'm not sure whether that is the right term to use!!). I obviously need to get the cheapest AB software that will do the job.
Any pointers gratefully received.
Thanks very much
Foggers