Hi all,
I've been working on a few Flex IO modules lately. I am setting up a second one with an IP. Here's what I've been experiencing:
1. Connect to device directly and launch BooTP.
2. Can find device via MAC and set IP.
3. Configure IP of device successfully. In this case 192.168.250.3.
4. As soon as I configure the device the module faults. Blinking module status light in RED.
5. In Linx it shows a comm error of 01E0024. It shows as unrecognized device and an X through it.
6. However I can still ping the device! (so odd). I can browse to the web gui of the device.
7. The device also has 1794-IB10x086 and 1794-IE4X0E2 connected to it. I thought it was a device fault there so I disconnected those and just have the AENT.
I tried resetting the device and tried again and same error. Any thoughts?
Thanks in advance.
I've been working on a few Flex IO modules lately. I am setting up a second one with an IP. Here's what I've been experiencing:
1. Connect to device directly and launch BooTP.
2. Can find device via MAC and set IP.
3. Configure IP of device successfully. In this case 192.168.250.3.
4. As soon as I configure the device the module faults. Blinking module status light in RED.
5. In Linx it shows a comm error of 01E0024. It shows as unrecognized device and an X through it.
6. However I can still ping the device! (so odd). I can browse to the web gui of the device.
7. The device also has 1794-IB10x086 and 1794-IE4X0E2 connected to it. I thought it was a device fault there so I disconnected those and just have the AENT.
I tried resetting the device and tried again and same error. Any thoughts?
Thanks in advance.