Good morning all,
I have a project that has quite a few NATRs to configure. I would like to modify the generated backup config file because I could write a script that will generate the rules and set public and private addresses. The problem I'm running into is when I try to load a modified config file I get the following fault "The configuration was unable to be restored from the SD card."
I think I've narrowed it down to some sort of checksum issue by changing the config through the web interface and comparing the files. One of the first lines in the XML backup file is <_1783-NATR SerialNumber="8445af24">. The SerialNumber isn't actually the serial number of the NATR and seems to be changing every time I change a setting.
Does anyone have any experience configuring these with the backup XML file or have any ideas how that value may be calculated?
I have a project that has quite a few NATRs to configure. I would like to modify the generated backup config file because I could write a script that will generate the rules and set public and private addresses. The problem I'm running into is when I try to load a modified config file I get the following fault "The configuration was unable to be restored from the SD card."
I think I've narrowed it down to some sort of checksum issue by changing the config through the web interface and comparing the files. One of the first lines in the XML backup file is <_1783-NATR SerialNumber="8445af24">. The SerialNumber isn't actually the serial number of the NATR and seems to be changing every time I change a setting.
Does anyone have any experience configuring these with the backup XML file or have any ideas how that value may be calculated?