Hi.
I am having trouble establishing comms between an slc5/04 and panel view plus 7 via a PLX51-net-eni.
The set up is:
5/04 Channel 0 DF1 protocol to PLX51, ethernet between PLX51 and panel view plus 7.
The HMI was migrated from an old 1400e to panel view plus 7, so I have changed left the original HMI tag names as they were and changed their addresses to suit the new plc short cut. I can browse tags from View Studio and I can use direct tags to test a particular button and that works. However using the HMI tags even with the correct address syntax for the plc short cut does not achieve communication.
I have followed the tech connect support instructions for setting this up but still no joy in design local or run time.
Thanks in advance for any help.
I am having trouble establishing comms between an slc5/04 and panel view plus 7 via a PLX51-net-eni.
The set up is:
5/04 Channel 0 DF1 protocol to PLX51, ethernet between PLX51 and panel view plus 7.
The HMI was migrated from an old 1400e to panel view plus 7, so I have changed left the original HMI tag names as they were and changed their addresses to suit the new plc short cut. I can browse tags from View Studio and I can use direct tags to test a particular button and that works. However using the HMI tags even with the correct address syntax for the plc short cut does not achieve communication.
I have followed the tech connect support instructions for setting this up but still no joy in design local or run time.
Thanks in advance for any help.