set one pulse to output in delta plc

reza.akbari

Member
R
Join Date
Apr 2015
Location
mashad
Posts
9
hello to all
I have DVP-14SS2 plc and I want to turn on just one pulse my output(for example y0)
imagine I have sensor in input(x1) and when ever sensor is high , y0 generate just one pulse high and then comes low
is there any command for doing this ?
thanks for your attention
 

Similar Topics

E
manually reset pulse timer before end of counter
Hello everyone‚ Fairly new to PLC prog I seek your advise concerning what is said in my thread title; I program using workbench components; I...
Replies
1
Views
1,285
parky
P
B
Pulse counter reset
Hi, im using an ip4 pulse counter module to measure flow rate of a substance for a project, have written my code but can't find how to reset the...
Replies
3
Views
1,363
brookes76
B
V
Omron Input Pulse to SET instruction
Hi all, I am fairly new to PLC programming, and just have a simple program regarding an unlatching input. In the picture below, I have STARTCOIL...
Replies
7
Views
3,270
gclshortt
gclshortt
B
No timer reset
Hello, I still do not have equipment in to test. But the RTAC ladder does not have a timer reset coil. I wonder if a reset coil on Timer.IN is...
Replies
1
Views
130
drbitboy
drbitboy
N
DVP-14SS2 program does not Run after Power Reset
Hi, i am using DVP-14SS2 PLC, after program written to plc, when power is reset, plc doesn't run. always need to connect to pc for the run mode.
Replies
0
Views
70
nadeem2nazar
N
Back
Top Bottom