steveo
Member
Okay PLC pros, I could use a little help getting
off of dead-center.
Silly me, thought I could just open up the com
port and log the data that would come streaming
from the PLC into a file and parse it... (duh)
I have a simple program problem.
I have a NO switch (M0) that drives a 10msec
counter (T0) to a constant value of 100, then
stops.
Q1. (while printing out the FX communication
manual on a slow inkjet...)
How do I configure to FX1N to add either/both
of CR/LF to its output?
Q2. What do I have to add to my ladder
program to put the data from T0 into a buffer,
and output the buffer to the com Port?
TIA
Steve
PS the FX1N is hooked to an F940GOT that is
connected via an RS232 cable to my com port
off of dead-center.
Silly me, thought I could just open up the com
port and log the data that would come streaming
from the PLC into a file and parse it... (duh)
I have a simple program problem.
I have a NO switch (M0) that drives a 10msec
counter (T0) to a constant value of 100, then
stops.
Q1. (while printing out the FX communication
manual on a slow inkjet...)
How do I configure to FX1N to add either/both
of CR/LF to its output?
Q2. What do I have to add to my ladder
program to put the data from T0 into a buffer,
and output the buffer to the com Port?
TIA
Steve
PS the FX1N is hooked to an F940GOT that is
connected via an RS232 cable to my com port