Hi guys
I am new to the threads and relatively new to the world of PLC programming.
During a recent programming session, I was using the Micro820 in DHCP mode when I blindly tried to configure a static IP address. In doing so and while connected, I managed to remove all IP address settings from the controller and now I can not connect, the ENET light is not showing any signs of life when I plug in (it should show green even without config) and windows diagnostics is telling me that my device does not have IP config.
While connected through DHCP, I changed my computers adapter settings to suit the 169.254.xxx.xxx address, then I changed the DHCP setting on CCW controller options while also unchecking the Port settings Disable button.
I have read that I can communicate with the controller through USB, but the recommended route is to use the LCD add-on.
Can somebody tell me if there is another way to connect directly through the comms port. Thanks!!
I am new to the threads and relatively new to the world of PLC programming.
During a recent programming session, I was using the Micro820 in DHCP mode when I blindly tried to configure a static IP address. In doing so and while connected, I managed to remove all IP address settings from the controller and now I can not connect, the ENET light is not showing any signs of life when I plug in (it should show green even without config) and windows diagnostics is telling me that my device does not have IP config.
While connected through DHCP, I changed my computers adapter settings to suit the 169.254.xxx.xxx address, then I changed the DHCP setting on CCW controller options while also unchecking the Port settings Disable button.
I have read that I can communicate with the controller through USB, but the recommended route is to use the LCD add-on.
Can somebody tell me if there is another way to connect directly through the comms port. Thanks!!