Studio5000, V31
I'm Messaging a MassFlow Meter, specifically to pull the Engineering Units (units of measure) for 6 instances.
Basically, do I need to have 6 MSG instructions using CIP Generic, Get Attribute Single? Or can I just use 1 MSG instruction to pull all the values I need?
Attached files are the values I am pulling:
Mass Flow > Engineering Units
Volume Flow > Engineering Units
Density > Engineering Units
Temperature > Engineering Units
Totalizer 1 > Engineering Units
Totalizer 2 > Engineering Units
I am getting the data I need correctly using 6 MSG, but this seems inefficient to have 6 different MSG instructions using Get Attribute Single, especially for just 1 Mass Flow meter.
Can I do this with just 1 MSG instruction?
Thank you so much
I'm Messaging a MassFlow Meter, specifically to pull the Engineering Units (units of measure) for 6 instances.
Basically, do I need to have 6 MSG instructions using CIP Generic, Get Attribute Single? Or can I just use 1 MSG instruction to pull all the values I need?
Attached files are the values I am pulling:
Mass Flow > Engineering Units
Volume Flow > Engineering Units
Density > Engineering Units
Temperature > Engineering Units
Totalizer 1 > Engineering Units
Totalizer 2 > Engineering Units
I am getting the data I need correctly using 6 MSG, but this seems inefficient to have 6 different MSG instructions using Get Attribute Single, especially for just 1 Mass Flow meter.
Can I do this with just 1 MSG instruction?
Thank you so much