Hi all,
I have an Allen Bradley PLC which is connected to a Kinetix 300 drive.
I have been using MotionView to adjust the different positions for a servo motor.
I have been adjusting the "Distance" parameter in the Index section of the drive. (See Attachment).
My questions are; should this distance value be readable by the PLC or OPC?
Can I write to this value from the PLC?
I have an Allen Bradley PLC which is connected to a Kinetix 300 drive.
I have been using MotionView to adjust the different positions for a servo motor.
I have been adjusting the "Distance" parameter in the Index section of the drive. (See Attachment).
My questions are; should this distance value be readable by the PLC or OPC?
Can I write to this value from the PLC?