Ryan_Flowers
Lifetime Supporting Member
Hello,
I have a set of three tanks with their own trio of Hardy 6600 series load cells. Two of them have no issues with where they are at and applying weight during a calibration was within tolerance. The last one has a negative value in the gross and net weight. This value goes up properly when applying weight, but obviously the program errors out with those values and shows zero at the HMI. I have used these types of loadcells in the past and their controllers to zero, tare, and hard calibrate. Problem is between the load cells and analog input card, there is no controller that I can find for any of these groups of loadcells. This does not allow me to zero from what I can tell. My question is; Does anyone know of a way to zero these values without a Hardy controller? There does not appear to be a command in the HMI or PLC logic that accomplishes this.
See attached photos of problem tag and the other that is working normal.
Thank you in advance for your assistance.
I have a set of three tanks with their own trio of Hardy 6600 series load cells. Two of them have no issues with where they are at and applying weight during a calibration was within tolerance. The last one has a negative value in the gross and net weight. This value goes up properly when applying weight, but obviously the program errors out with those values and shows zero at the HMI. I have used these types of loadcells in the past and their controllers to zero, tare, and hard calibrate. Problem is between the load cells and analog input card, there is no controller that I can find for any of these groups of loadcells. This does not allow me to zero from what I can tell. My question is; Does anyone know of a way to zero these values without a Hardy controller? There does not appear to be a command in the HMI or PLC logic that accomplishes this.
See attached photos of problem tag and the other that is working normal.
Thank you in advance for your assistance.