Hi,
Attach is the program for one of my developing system, which consists of 3150-MCM in the last slot (11). I've not configured any Slave port for 3150-MCM beforee.
I'm only using the Port 1 of te 3150-MCM & being configured into Slave. It'll be communicating with a Master (DCS).
I'm pulling/writing the data using ModScan32 as I do not have DCS in my office.
When I configure the word count (N10:54 & N10:64) to 10 words, it's suppose to update 10 words, but in my program it's updating more than 10 words! Same goes to Read & Write Block.
Is it because this is slave and I cannot limit the words count? or disabling the entire command?
Hope some can enlight me
Thx in advance.
Attach is the program for one of my developing system, which consists of 3150-MCM in the last slot (11). I've not configured any Slave port for 3150-MCM beforee.
I'm only using the Port 1 of te 3150-MCM & being configured into Slave. It'll be communicating with a Master (DCS).
I'm pulling/writing the data using ModScan32 as I do not have DCS in my office.
When I configure the word count (N10:54 & N10:64) to 10 words, it's suppose to update 10 words, but in my program it's updating more than 10 words! Same goes to Read & Write Block.
Is it because this is slave and I cannot limit the words count? or disabling the entire command?
Hope some can enlight me
Thx in advance.