Omron Cp1W-DAB21V Option Board Error

Wiresplus

Member
W
Join Date
Sep 2021
Location
Auckland
Posts
17
Hello,
I have a CP1H-XA4001 PLC, with a CP1W-DAB21V option board.
The moment I insert the board, the PLC goes into Error.
I set the dip switch to auto - same result.
I went into settings, and set serial port 1 as 115200 and ToolBus.. Still no change


Has anyone any experience with these and can point me in the right direction?🤞🏻
 
It displays the PLC error light, then about 3 seconds or less later the DAB error light. The display on the PLC says D.1.[flashes]0.0.
 

Similar Topics

A
Omron CP1W-DAB21V
Hi all, This is my first post on here, hopefully you can all help. I'm very new to PLC's and have been given a project at work that's currently...
Replies
6
Views
3,719
aandjsam
A
O
Omron-CP1W-DA041
There have 2 different value in configuration output 2 on Omron CP1W-DA041 manual which one the correct? thanks for your time.
Replies
4
Views
2,295
gtsuport
G
C
Omron CP1W-C1F41
Ok I have an CP1W-C1F41 Ethernet Comm module added to my CP1L PLC. What I am trying to do is set it up (IP address etc). I can not find a manual...
Replies
1
Views
2,608
sbaum
S
bernie_carlton
Beginning Omron CP1H CP1W
Brand new to Omron My supplier speced CP1H-XA490DT1-D CPU with 2 CP1W-20EDT1 expansion modules Using CX One Lite I can't select the CP1W units...
Replies
9
Views
3,182
iant
iant
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
4
Views
76
Mihir_007
M
Back
Top Bottom