I have a spare ENBT module on a remote rack at slot 3 that communicates to a privately addressed EN2T module at 192.168.1.2 on the main rack via another EN2T module on the remote rack at 192.168.1.19 at slot 2. Our intent is to readdress this spare so that it communicates with the control network at 10.8.206.21.
Do I change the IP address of the spare module to the desired 10.8.206.21 and download, then change the address in the module configuration in Linx appropriately? Also, I'm not sure where the new module would be indicated in Linx. I am assuming at the same subnet layer as the main PLC and Panelview, which are at 10.8.206.19 and 10.8.206.20 respectively.
Thanks!
Do I change the IP address of the spare module to the desired 10.8.206.21 and download, then change the address in the module configuration in Linx appropriately? Also, I'm not sure where the new module would be indicated in Linx. I am assuming at the same subnet layer as the main PLC and Panelview, which are at 10.8.206.19 and 10.8.206.20 respectively.
Thanks!