TimeFluxCap
Member
Hi all
I have just used Com Profibus V5 to setup a profibus network where a TI505 is the master ad a ControlLogix with a Prosoft Profibus card is a slave.
The Com Profibus came on the disk with the TI505 WorkShop software.
My question is - is this Com Profibus V5 the same program you would use to setup a Profibus netwrok with S7-300 PLCs or does it use different software?
Thanks Siemens / Profibus people !
I have just used Com Profibus V5 to setup a profibus network where a TI505 is the master ad a ControlLogix with a Prosoft Profibus card is a slave.
The Com Profibus came on the disk with the TI505 WorkShop software.
My question is - is this Com Profibus V5 the same program you would use to setup a Profibus netwrok with S7-300 PLCs or does it use different software?
Thanks Siemens / Profibus people !