232 to 485 or 485 to 232 confusion.

Many Thanks Kittydog,

I will try one of these units but don't expect to have much success. I thought others here would have already tried.

Regards,
Barry.
 
The PPI converter converts to a propriety protocol. Are you trying to access the programming port, a 485 port or the modem module?
 

Similar Topics

i have an device which can support serial (RS485,RS232),CAN protocol . i want to connect it to an existing MIB 1553B bus ,what device will I need...
Replies
0
Views
55
Hello: I have to connect a RS232 Modbus RTU slave that only has Tx, Rx and GND signals to a Modbus RTU master. However, all RS232 to RS485...
Replies
3
Views
204
Hello, Can a single DB-9 or mini-DIN8 port be used to interface with RS-232 or RS-485 serial connections? Thanks, EE
Replies
5
Views
1,697
For connecting to a Micrologix through a 1761-NET-AIC, the manual specifies that you should use "RS 232 Communication Cables Cable, Cat. No...
Replies
0
Views
1,345
Hello everyone, I have a micrologix 1400 series PLC ( 1766 L32BWAA) and it has 3 ports, port 0 (for RS232/485), port 1 ( LAN ,RJ45) and port 2...
Replies
12
Views
4,891
Back
Top Bottom