ADDMX function setup for BMENOS0300 in a M580 Remote drop

xcyong89

Member
Join Date
Oct 2019
Location
Kuala Lumpur
Posts
11
Hi,

How is a ADDMX function setup to communicate to slave devices (Modbus TCP/IP) that connected to BMENOS0300 in a M580 Remote drop.

I have search the Q&A in Schneider Electric website. However I did not find any related Q&A on this topic.
 
Last edited:
BMXNOM0200 is applied for Modbus RTU. From the FAQ, the configuration for is BMXNOM0200 shows as below:

r0.s0.ch0{ip.ip.ip.ip}\\r1.s1.ch1.d

r0.s0.ch0 must be 0.0.3

ip.ip.ip.ip = IP address of BME CRA 31210

r1.s1.ch1 = rack number of BMXNOM0200, slot number of BMXNOM0200 and channel number of BMXNOM0200

d = Modbus ID of slave device in Modbus RTU

However, I did not find any FAQ that related to Modbus TCP/IP that using BMENOS0300 in M580 Remote drop communicate to slave devices
 
Isn't NOS0300 module switch which is installed to local or remote rack ethernet slots?


Manual have this



NOTE: Use the IP address of the CPU, and not the address of the BMENOS0300 switch, to communicate with the CPU.


So is this meaning that you have to address you master communication same way than your would communicate directly out from CPU's embedded port and Switch (NOS0300) is mirroring all packets that CPU is sending?





Try 0.0.3{target_ip}TCP.MBS??
 

Similar Topics

Im trying to create a level indicator for water Tank i have used the ADD function while the pump is on and level increasing everything works...
Replies
17
Views
164
Good morning crew! Ok my logic works but I am missing something. When the start button is pushed it should like the red light for 4sec then shut...
Replies
13
Views
349
Please see attached file. I need this program in Function Block form but I am totally lost on this. Any help would be appreciated. Thanks!
Replies
8
Views
258
The idea here is to provide for a brief rapid influx of message codes while preventing sequentially repeating the same message. i.e. if two...
Replies
23
Views
519
Howdy, I am currently struggling with an array of values that I want to re-arrange in a programmatic way. My program is a mix of ladder and STX...
Replies
6
Views
365
Back
Top Bottom